#commodore #CRT #1084S In this video I set out to replace the sticky switch on my 1084S CRT monitor. I found a guide that used the CANAL PSD-1 switch http://personalpages.tds.net/~rcarlsen/cbm/monitors/switch/mon-sw.txt and I used that to create my own 3d printed support bracket for the new switch. You can down load the STL from https://www.prusaprinters.org/prints/106671-commodore-1084s-power-switch-support

I use m3 machine screws to screw the switch to the new support and then 3mm self tappers to secure the support to the PCB.